Categories

Newsletter

4 x PixLite Long Range Receiver Maximize

4 x PixLite Long Range Receiver

A pack of 4 fully assembled entry-level receiver boards for the PixLite Long Range Controllers.

More details

4PIXLRR

US$50.00

This is the receiver board that is ONLY used in conjunction with the PixLite Long Range Control boards.

The PixLite Long Range controllers send data signals over 300m+ and they are converted back to a pixel-ready signal at the other end by these small receiver boards. The long distance signal is sent using a differential pair which elimates the typical problems seen in pixel systems (crosstalk, signal degradation, reflections, etc) which otherwise prohibit pixels being installed far from the controller. The PixLite Long Range system also eliminates the need for any null pixels.

The controller uses standard Cat5/6 cables to transmit the signals. Any standard network cable can be used for the connection between PixLite Long Range Controller and these Receivers.

The receiver can operate in 2 modes which is set by the transmitting controller.

Mode 1: Normal - The receiver drives 2 pixel outputs of any supported pixel type.

Mode 2: Condensed/Expanded - The receiver drives 4 pixel outputs of any DATA ONLY pixel type. I.E. If the pixels only have a data line and no clock (like the WS2811 protocol), the receiver can drive 4 sets of pixels at the same time.

The maximum number of pixels per output is set by the controller.

Additionally the receiver board comes with 2 onboards fuses for the outputs and pluggable output connectors. Each output is rated to 7.5A maximum and comes with 7.5A fuses installed. These fuses can be reduced to suit your application.

The isolated version of the receivers have additional benefits and are recommended in all cases where budget allows.

Cart  

No products

US$0.00 Shipping
US$0.00 Total

Cart Checkout