PixLite 16 Long Range MkII Maximize

PixLite 16 Long Range MkII

A fully assembled long range RGB pixel mapping controller that can control 16,320 RGB pixels or 12,240 RGBW pixels and 4 DMX512 universe outputs. (100 Universes of input data.) 

Free local shipping within Australia and USA!

More details



The PixLite16 long range MkII controller converts Art-Net or sACN (E1.31) data via an ethernet connection to pixel data for driving LED pixel lighting.

The PixLite Long Range MkII sends the data up to 300m+ distance and is converted back to a pixel ready signal at the other end by small receiver boards. The long distance signal is sent using a differential pair which elimates the typical problems seen in pixel systems (crosstalk, signal degradation, reflections, etc) which otherwise prohibit pixels being installed far from the controller. The PixLite Long Range MkII also eliminates the need for null pixels.

The controller uses standard Cat5/6 cables to transmit the signals. Any standard network cable can be used for the connection between PixLite Long Range MkII Controller and the Receivers.

The controller can operate in 2 modes:

Mode 1: Normal - The controller can drive up to 8 receiver boards. Each receiver drives 2 pixel outputs of any supported pixel type. Each of these 2 outputs is able to drive 1020 RGB pixels in this mode. 

Mode 2: Expanded - Each receiver drives 4 pixel outputs of any DATA ONLY pixel type. I.E. If the pixels only have a data line and no clock (like the WS2811 protocol), the receivers can drive 4 sets of pixels (up to 510 RGB pixels per set) at the same time. The controller uses all 8 output jacks to send all 32 output channels in this mode. (Number of pixels per data line in this mode is halved compared to using normal mode.)

It supports the following input protocols:

-sACN (E1.31)

It can handle up to 96 universes of Multicast/Unicast E1.31/Art-Net data and controls up to 1020 RGB pixels on each of the 16 outputs.

It is also capable of simulataneously outputting 4 DMX512 universes (acting as a E1.31 to 4 x DMX512 bridge, no Art-Net to DMX) in addition to the 96 universes of pixel output.

Outputs to the following IC types:

TLS3001, SM16716, LPD6803, WS2801, WS2811/12/12B/13/18, APA102/104, TM180x, MBI6020, INK1003, SK6812, UCS1903, MY9221, MY9231. Note: one pixel type at a time per controller.

The controller also interfaces with our GUI utility for easy configuration and uploading of new firmware.

Please go here for more detailed information about this product.


No products

US$0.00 Shipping
US$0.00 Total

Cart Checkout